RO no water from the tap: seven checks before a new purifier

A dry RO tap is often a closed inlet, a packed sediment stage, or a booster that ran dry — not an automatic new stack from Chellikere.

18 November 2026 · 3 min read

RO tap with no product water during a Bangalore repair visit
RO tap with no product water during a Bangalore repair visit

The seven checks we run on the visit

1. Inlet tap actually open. 2. Overhead or tanker tank not empty. 3. Sediment cartridge brown and blocking flow — see sediment and carbon stages. 4. Low-pressure switch. 5. Booster that already ran dry into a wet tray — housing leak. 6. Frozen solenoid. 7. Membrane so packed that reject and product both stall.

This is a repair call from All Brand Water Purifier, Chellikere, Meganahalli, Kalyan Nagar 560043. Independent — not OEM. Phone +91 98457 81177.

What Bangalore mixed supply does to flow

Tanker days after summer push grit into the first housing. Kitchens in Whitefield and Marathahalli report a dry tap the morning after a tanker fill. That is a pre-filter, not a new Kent or Aquaguard frame.

Book with a photo of the housings. Coverage is the areas list. Filter life still follows when to change RO filters, not a 90-day sticker.

Questions on a dry tap

Should I keep the switch on? No, if the tray is wet or the pump is screaming. Is UV-only the same fault? UV units without a booster fail for different reasons — we still start with inlet and carbon. See RO vs UV.

Questions we get on this job

Is no water from the RO tap a new purifier?

Usually not. Inlet, sediment and booster come before a stack swap on the Chellikere bench.

Can I run the pump if the tray is wet?

No. Close the inlet. A dry-run booster is a second parts job. Book repair.

Keep reading

All Brand Water Purifier · Chellikere, Meganahalli, Kalyan Nagar, Bengaluru 560043 · +91 98457 81177